Video Direct Link | Abstract

Abstract ABS-36

Optimization of the toolpath strategy for the master ceramic jewelry mold pattern using the Rhinoceros software and Retrovit CNC machine Stefanus W. Ratnanta (a), P.W. Anggoro (a)*, P.K. Fergiawan (b), J. Jamari (b)- A.P. Bayuseno (b) Corresponding Author: Stefanus Widi Ratnanta

Question from Mr. Abet Adhy Anthony 2020.11.18 15:17:25 Why use the horizontal toolpath for roughing process, and parallel for finishing process?

Reply from Mr. Stefanus Widi Ratnanta 2020.11.18 15:36:48 Horizontal roughing method is good for removing materials quickly, so that the machine can finish the process easily. then parallel method creates an efficient material process. The tool moves along a parallel cut pattern that follows the contours on the top of materials. This method fit to smaller tools and tigher tolerances for good control surface quality.

Powered By Konfrenzi Ultimate 1.832L-Build7 © 2007-2025 All Rights Reserved