Video Direct Link | Abstract

Abstract ABS-37

Development of the ceramic jewelry industry for necklace with Indonesian batik motifs C.D. Mahendri1- P.W. Anggoro1*- P.K. Fergiawan2- T. Yuniarto1- A.P. Bayuseno2- Jamari2 Corresponding Author: Christoper Devon Mahendri

Question & Answer to the Presentation

Question from Mr. Abet Adhy Anthony 2020.11.18 15:24:27 Why product shrinkage must be below 15% ? Replies: Reply from Mr. Christoper Devon Mahendri 2020.11.18 15:42:39 Hi Mr. Anthony, Thank^s for your question Because if the shrinkage is more than 15% the product resulting from the system process will shrink far enough from the desired initial design. The motifs and contours of the jewelry are not detailed so that they cannot be marketed.

Question from Ms. Silvya Yusnica Agnesty 2020.11.18 14:43:06 Hi Mr Christopher, in the slide of the fabrication process of ceramics in this research. There is a wash and soak the master product process. may I know what is the function of this soaking process? Thank you. Replies: Reply from Mr. Christoper Devon Mahendri 2020.11.18 15:14:45 Hi Ms. Silvya Yusnica Agnesty, Thanks for your question It^s function is to clean the master product from dirt and provide moisture to the product master, so that when printed it is easily removed with white gypsum.

Question from Mr. M. Muchammad 2020.11.18 14:35:17 which the most difficult pattern to be analyze and produce? Replies: Reply from Mr. Christoper Devon Mahendri 2020.11.18 15:20:41 Hi Mr. Muchammad, Thank^s for your question. The pattern that is most difficult to analyze is the pattern with a small size, in this study the Megamendung pattern. While the pattern that is difficult to produce is the pattern with the largest dimensions, in this case the Flora pattern.

Powered By Konfrenzi Ultimate 1.832L-Build7 © 2007-2025 All Rights Reserved